Fte maximal MEDIAMAX MINI S2 CT Manuel d'utilisateur télécharger pdf (Page 52)

User’s Manual - mediaMAX MINI

Reserved of technical modiﬁ cations and/or errors

ENGLISH

rev 2.1

10.3 Cable signal measurement

10.3.1 Frequency band selection

For cable band selection, press one or several times

“band” key until the monitor shows the message

“Switching to satellite band”. The switching sequence is the following:

Terrestial band -> Cable band -> Satellite band

Once this option has been selected, a cable logo appears on the left top of the status bar.

In case of the meter doesn’t show the above message, it could be necessary to go into the

“setup”

menu, select

“RF” option and active “show cable band”.

10.3.2 Use spectrum mode to spot a signal

To represent the frequency spectrum on the screen and spot a signal, press the

“spectrum” key.

When this selection is active, the green led over the key will be switched on.

To identify a signal, to do it with a span of 50 MHz is advised (default value in cable). For select it, use

left and right arrows keys. The span current value is shown at the left bottom part of the monitor.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 123 124

Pas de commentaire

Fte maximal MEDIAMAX MINI S2 CT Manuel d'utilisateur Page 52